|
本帖最后由 清水白菜 于 2012-9-25 13:58 编辑
* n. p8 T/ E; V1 r6 f. H' A; q' G6 \5 }
' O% L7 ]- ]4 C' d) G, uIn addition, double and reinforced insulation shall withstand the partial discharge test according to 7.5.3, if the recurring peak working voltage across the insulation is greater than 700 V and the voltage stress on the insulation is greater than 1 kV/mm.
0 _! z( z" t9 ?- W; xCompliance is shown by impulse withstand voltage test according to 7.5.1 and the a.c. or d.c. voltage test according to 7.5.2, and partial discharge testing according to 7.5.3 if applicable.
$ ]6 w) _% k* T2 Q2 h% w K4 k6 h3 N; I5 U, b0 n" D# a6 W
Starting from a voltage below the rated discharge voltage UPD a, the voltage shall be linearly increased to 1,875 times UPD and held for a maximum time of 5 s% @/ R5 F4 h8 D7 P+ c- S
The voltage shall then be linearly decreased to 1,5 times UPD (± 5 %) and held for a maximum time of 15 s, during which the partial discharge is measured
% \, \, a8 F" P# @$ T1 SThe test shall be considered to have been successfully passed if the partial discharge is less than 10 pC during the measurement period4 ^0 H1 }8 B$ x, S B5 P
7 Q5 I3 d8 Q* t) f- j: A, ^+ C y至于测试设备,网上一搜索就有了。; Q+ {/ E& D% f$ n' i$ X4 b
|
|