PDSH 005/07 Luminaires provided with LEDs
http://decisions.iecee.org/icons/ecblank.gif PDSH 005/07
Luminaires provided with LEDs
General Section 12
60598-1(ed.3);am1 & 60598-1(ed.4);am1 & 60598-1(ed.6);am1 & 60598-1(ed.7) & 60598-2-6(ed.2);am1 & 61347-2-11(ed.1) & 61347-2-13(ed.1) & 60825-1(ed.1) & EN 60825-1:1994
Standard: IEC/EN 60598-1
IEC/EN 60598-2-6
IEC/EN 61347-2-11
IEC/EN 61347-2-13
IEC 60825-1/1993 (§)
EN 60825-1/1994 (#)
Sub clause: General
Section 12
Sheet N°: 005/07
Page: 1(1)
Subject: Luminaires provided with
LEDs
Key words:
- Control gears
- Section 12
- IEC/EN 60825-1 (§) -
(#)
Meeting:
To be approved at
CTL 45th meeting
Question: Is it possible to approve luminaires provided with LEDs?
Decision: Yes, provided that:
- the LED circuit shall be verified according to IEC/EN 61347-2-13 or IEC/EN
61347-2-11 (*) and the LED shall be tested according to IEC/EN 60825 –1
(Safety of laser products) (§)-(#), if it has laser radiation in the wavelength
ranging from 180 nm to 1 mm. Only LEDs classified as Class 1 lasers can be
used without problems for lighting purposes without protection.
- The thermal tests required in Section 12 of IEC/EN 60598-1 shall be carried
out as follows:
a) Luminaires (Class I or II) with built-in control gear shall be tested
according to the requirements of IEC/EN 60598-2-6.
b) For Class III luminaires the manufacturer shall provide the necessary
information to power up the LED circuit correctly in the instruction sheet.
Alternatively, the manufacturer shall inform Testing Station about the
trade mark, the type and the technical characteristics of the appropriate
control gear to be used. There are three different control gears namely, the
type and the trade mark as indicated by the luminaire manufacturer; an
electronic control gear clearly specified in the luminaire instruction sheet
and a ferromagnetic control gear. The tests shall be carried out as required
in Section 12 according to IEC/EN 60598-2-6 with the appropriate control
gear.
(*) When IEC/EN 62031 (34A/1168/CDV) will be published, it will takes
over IEC/EN 61347-2-11.
(§) + A1/1997 + A2/2001
(#) + A1/2002 + A2/2001
页:
[1]
