DSH 005/05 Luminaires provided with LEDs
http://decisions.iecee.org/icons/ecblank.gif DSH 005/05
Luminaires provided with LEDs
General Section 12
60598-1(ed.3);am1 & 60598-1(ed.4);am1 & 60598-1(ed.6);am1 & 60598-1(ed.7) & 60598-2-6(ed.2);am1 & 61347-2-11(ed.1) & 61347-2-2(ed.1);am1;am2 & 60825-1(ed.1);am1;am2
Standard: IEC/EN 60598-1
IEC/EN 60598-2-6
IEC/EN 61347-2-2
IEC/EN 61347-2-11
IEC/EN 60825-1
Sub clause: General
Section 12
Sheet N°: 005/05
Page: 1(1)
Subject: Luminaires provided with
LEDs
Key words:
- Control gears
- Section 12
- IEC/EN 60825-1
Meeting:
CTL No. 42
WG1 No. 1 - 2 - 3
Item: 10.5.1
Question: Is it possible to issue approvals on luminaires provided with LEDs light source?
Decision: Yes, provided that:
(1) The LED circuit is verified according to IEC/EN 61347-2-2 (*) or IEC/EN
61347-2-11. If the laser emits radiation in the wavelength range from 180 nm to 1
mm, the LED shall also be tested according to IEC/EN 60825 –1 (Safety of laser
products). Only LEDs classified as Class 1 lasers can be used without problems
for lighting purposes without protection.
(2) The thermal tests required in Section 12 of IEC/EN 60598-1 are carried out as
follows:
(a) Luminaires (Class I or II) with built-in control gear can be tested
according to the requirements of IEC/EN 60598-2-6.
(b) For Class III luminaires, the luminaires manufacturer shall provide on
the instructions all the necessary information to supply the LED circuit
correctly or shall inform the Testing Station about the trade mark, the type
and the technical characteristics of the appropriate control gear. There can
be three different control gears: the type and the trade mark indicated by the
luminaire manufacturer; an electronic control gear clearly specified on the
luminaire instructions; a ferromagnetic control gear. The tests shall be
carried out as required in Section 12 according to IEC/EN 60598-2-6 with
the appropriate control gear.
(*) When IEC/EN 61347-2-13 will be published, it will takes over IEC/EN
61347-2-2.
页:
[1]
