此为一adapter，Rated input： 100-240V 0.35A 50/60Hz Single Phase( L+ K! B/ v) R" u$ `* n# l, }
Rated output： 5V 2A
' o4 m7 _0 r9 d* W1 Q8 K) R Maximum Output Power: 10W
6 V, ?) Y8 n4 P# ~3 u Maximum Ambient: 40 C(度)
: y7 ?. z: Y. p. a; W2 v$ o4 c6 P希望安规前辈能对data sheet中的点进行讲解（标准的理解，本项测试的本质，每项被测数据的测试方法，仪器选用的原则，测试过程中的注意事项），以供大家交流讨论以及新人学习之用，谢谢！
1 ^0 t4 \1 O6 d9 q2 c& r& K/ H, Y, E, t/ w# A
1.2.2.1 –MAXIMUM OUTPUT VOLTAGE, CURRENT, AND VOLT-AMPERE MEASUREMENT TEST METHOD A sample of power supply, Model ______was connected to _240_[Vac,_60_Hz][Vdc]. The following parameters for each output were measured: A: The maximum peak output voltage (V) under any resistive loading condition. B: The maximum rms output current (A) under any resistive loading condition [after][at] 60 seconds. C: The maximum volt-Ampere (VA) under any resistive loading condition [after][at] 60 seconds. RESULTS | Output tested | Maximum | HAZ/EL[Yes][No] | (V) | (A) | (VA) | 1. | | | | | | 2. | | | | | | 3. | | | | | | 4. | | | | | | Comments: |
2 C2 c0 m% b- d. X: pNOTES TO LAB: 1. Output which exceeds 240VA is considered to be hazardous energy level (HAZ/EL). 2. Indicate the load used for each test condition. NOTES TO ENGINEER: 1. Indicating loading condition (s) for output (s) not under test. 2. These measurements are to be taken for QQGQ2 Guiducard information. Addition testing in the end-use application may be necessary to determine if an energy hazard exists. ! G9 N6 Y6 T# b; Y( E7 j0 }' x
# v) h0 ^: u: S# k& u
| 
/1 
|关于安规|小黑屋|安规QQ群|Archiver|手机版|安规网
( 粤ICP13023453-10 ) 
窥视卡
雷达卡
发表于 2012-2-18 14:48
提升卡
置顶卡
沉默卡
喧嚣卡
变色卡
抢沙发
千斤顶
显身卡
发表于 2012-2-18 14:55
