|
引用第2楼Andy.Yang于2010-05-20 11:13发表的 :% Y* F+ F7 R7 N
You can
, L# U" _9 Q/ N1. Check the surger protector's datasheet to check whether the dielectric performance is higher than the whole product's requirement, if not, I think it's the surge protector's issue;
0 m5 ~! e9 C! ?0 e3 Q# r8 }* f0 u2. Check if there are some capacitors with low voltage rating, if there are, disassemble them or change the test voltage from AC to DC;
- E, |" p* ^0 K$ D( s9 u3. Adjust the leakage current setting to higher level, but still within the standard's requirement;+ q. l- U' t6 t/ M( u0 C
4. If all above proves that there is still a problem when doing this test, then verify the products step by step, try to find out which section or which components can not fulfill the test's requirement, then solve it...
7 ?( w/ q* x5 ^ i多谢 多谢 基本上找到原因了! |
|