|
本帖最后由 passagere 于 2017-3-31 07:47 编辑
; F( W/ }7 S+ T4 F9 C3 u; z: D. J) ^4 A) h9 H( e' ^ I: j
For luminaires with supply cords, the arrangement of the terminals, or the length of the# P4 Z8 F( c- o2 A- p/ L6 n) e
conductors between the cord anchorage and the terminals, shall be such that, should the cable7 {, {$ d+ _, s) I
or cord move out of the cord anchorage, the current-carrying conductor becomes taut before# f" U3 ?3 e. c) q
the earthing conductor.9 a% X% H- g9 B6 N1 O, e: A
" L4 |5 N3 w3 u- c/ _
这是60598标准原文,terminal是包括端子的,其实应该是任何连接导线的位置都可以称呼为terminal,比如常见的导线焊接于PCB上的焊点,如果非要端子才适用,有违标准本身的含义。毕竟焊接在PCB上或者固定好的连接器上的terminal,对芯线的拉扯力最强。! d& F% M2 z" \# s
, T( F% J" o1 v N
以下是维基百科的定义:
# m/ Q/ _) z$ z6 f0 J5 k% l# [7 zA terminal is the point at which a conductor from an electrical component, device or network comes to an end and provides a point of connection to external circuits. A terminal may simply be the end of a wire or it may be fitted with a connector or fastener.
3 C a6 T- v" V |
|