|
现在又推迟了. 下面是部分信息, 详见: http://www.energyrating.gov.au/eps2.html6 ^! J% T5 H& Y$ s* A
# V# M" {7 N0 Y
MEPS Requirements for External Power Supplies& R+ Z) p. ?$ X& F; y( o
It is expected that from 1st December 2008 in Australia and 1st April 2009 in New Zealand (see update to introduction date and scope - released 24 April 2008) most External Power Supplies with a nameplate output power rating up to 250 Watts, manufactured or imported for sale in Australia or New Zealand will be required to meet minimum energy performance requirements (MEPS). Introduction of MEPS is still subject to a regulatory impact statement and approval by the Ministerial Council on Energy.) U2 D5 K+ ] ]
7 H$ a1 |( Q1 F( `
The intention of MEPS is to increase energy efficiency by eliminating low efficiency external power supplies from the market and to encourage the use of high efficiency power supplies.
' {! V) \+ U5 q: C+ I) G2 n. ?1 D6 n3 L3 [: {, x9 i1 |# \4 e+ q0 V2 S5 F
Products covered include external power supply units (often known as 'a.c. adaptors', 'plug packs' or 'power-packs') with a nominal 230 V a.c supply supply input and a single output at extra low voltage (ELV), either a.c. or d.c., and a maximum output of 250 W or 250 VA.
& r* c2 B3 h) r9 Q; V! @" X1 s+ k- p' ]" \7 K* z+ A
The units covered are not built into the equipment being powered and hence are 'external' to the device being powered. Designs covered include units with an integral mains plug, 'in-line' units and units with provision for equipment to sit in a cradle whilst being used.! H$ b1 _' N+ D' Z0 ~/ f' w& o. g
2 q: ?6 h6 x- Y r( ^
A single output external power supply which is covered by MEPS is defined as a unit which: B/ v9 A7 s2 |8 {" n
; y. e5 S, U4 l7 `7 H% k y
has an input from mains supply (usually 110 V, 60 Hz; 230 V, 50 Hz; 240 V, 50 Hz or a range including some or all of these input conditions); and
2 D9 [/ d" ?4 ^/ x- _7 v, ?has one ELV output (either a.c. or d.c.) that is either at a fixed voltage or user selectable through a selector switch; and
' U! U K$ ]$ x; Y" [- ?2 @6 l8 @5 ~is sold with, or intended to be used with, a separate end-use product that constitutes the primary load; and 3 p) y# C0 Z) E* {4 ~( U0 Q- U: [0 x/ B
is contained in a separate physical enclosure from the end-use product (i.e. the housings of the power supply and its associated product are different, not their retail packaging); and
3 G& d1 u0 e3 O. e- e5 P- B. ais connected to the end use product via a hard-wired or removable male/female electrical connection, cable, cord or other wiring; and , u- z+ h6 R; C+ v1 H9 D
does not have batteries or battery packs that physically attach directly to the power supply unit (including those that are removable e.g. a battery pack for a portable electric drill); and
$ V1 i3 w2 t; L3 ]% m8 L; M, R9 zdoes not have a battery chemistry or type selector switch and an indicator light or state of charge meter. |
|