|
求组各位EMC大大~~/ A4 K% s( ^) ]" q
" u/ H% I# W8 E, E, L$ P- D- T
& z! e( F4 m K& K/ R& a# W章节6里面A simplified test method is permitted for equipment that undergoes minor changes or updates,# |( y( P' h) ]
provided that, in previous full compliance tests, it has been shown to have current emissions& ?* X/ Q( ]' t, ]
below 60 % of the applicable limits and the THD of the supply current is less than 15 %. The
% |# G0 a" ~5 @; }simplified test method consists of verifying that the updated equipment has an active input
0 g, W/ b; U4 b' m! P9 Jpower within ±20 % of that of the originally tested product, and that the THD of the supply
( u1 y/ m( |$ X! w/ W9 @) scurrent is less than 15 %. Products that fulfill these requirements are deemed to comply with) {0 _8 c0 w0 ~
the applicable limits, but in case of doubt the result of a full compliance test according to
: Z8 l9 ]* Y, r2 Y- n A M: BClauses 6 and 7 takes precedence over this simplified method.这里是指测试产品之前经过完整的测试,假如对产品进行了细微的升级。
) ?+ G% M! k) l3 p% V# h/ R$ B) l( g我之前完成测试时满足谐波低于60%,THD低于15%。
- K& y! P6 ` Q' S那么我升级之后的产品如果功率在原来的±20%之间,THD测试值仍低于15%。我就认为是符合要求的?2 K3 k8 v8 F' Z# r/ x- N6 z
9 v9 f8 _) o/ v# J+ M* Z. A0 ]8 k# k
& ~! i3 }6 P$ W. R5 @/ _5 F# H |
|