UL1310 固有限制，非固有限制区别？

BV211

广东安规检测
有限公司提供：

小型摆管淋雨试验机

IPX5X6X7喷水试验机

1000L恒温恒湿箱

各种试验指现货

可程式恒温恒湿试验箱

水平垂直燃烧机

自动卷线器试验机

耐划痕试验机

各种灯头量规现货

灼热丝试验机现货

GB1002插头量规

IPX1-X7淋雨现货

IEC61347/UL935镇流器热试验箱

灯具防风罩

IK冲击试验机

UL498插头插座量规

VDE0620插头插座量规

稳定性试验台

家电温升测试角

针焰试验机现货

热电偶焊机现货

家电125mm试验指

E12灯头量规

无绳壶无绳电熨斗插拔寿命试验机

IEC60335试验指甲

1. UL1310 固有限制，非固有限制区别？
2.  什么是 energy limiting impedance？
30.2 Inherently limited
30.2.1 Under any condition of resistive loading – including short-circuit and interconnection of outputs
% s2 }& l% u7 ?- E1 Ywhen not prohibited by marking – the maximum output current shall not exceed the value specified in
Table 30.1 and the maximum output volt-amperes shall not be more than 100 volt-amperes, except as
indicated in 30.2.3 and 30.3.1, for the following conditions, as applicable:
a) For a unit which employs a transformer with no form of protection, the measurement is to be
made 60 seconds after the unit is connected to the source of supply.
( ]9 \# s" C! T: N; Jb) For a unit which employs a transformer and an energy limiting impedance or energy limiting
circuit (a resistor, a PTC device, or similar circuitry) required for the purpose (See 2.8), the
measurement is to be made five seconds after the unit is connected to the source of supply.
c) For a unit which employs a transformer and either a thermal cutoff, a fuse, or both, all
protection is to be defeated during the test and the measurement made 60 seconds after the
9 M* i$ N' ~9 ?+ E* k" I- v8 Yunit is connected to the source of supply.
) R# A5 g, Z+ h$ D. Ed) For a unit that employs a transformer and a combination of a limiting impedance or circuit
required for the purpose, and a protective device (such as a thermal cutoff, a fuse, or both), all
" R5 Y( q) R4 Z9 c, X  k! i# l$ jprotective devices are to be defeated and the measurement is to be made five seconds after
the unit is connected to the source of supply.
e) For a unit that employs a dc input, in accordance with 1.1, and a combination of a limiting
impedance or circuit required for the purpose, and a protective device (i.e. thermal cutoff, fuse,
or both), the protective device is to be defeated and the measurement is to be made five
seconds after the unit is connected to the source of supply.

head0819

1. 固有限制--是指在短路和输出之间的内连接，最大输出电流不得超过表30.1中指定的值，并且最大输出VA不得超过100VA。
2. 非固有限制--在30.2.1中指定的最大电流和VA值不超过表30.2的值。
" c" x& Y% C/ G5 n' E+ v5 p6 S. f3. energy limiting impedance 就应该是指保险电阻，PTC。