本帖最后由 H-RH 于 2013-6-30 01:28 编辑 / `+ Z4 j# a3 ^# m, G5 t
# l N- ]3 `" Y7 Z! i: g你说的应该属于 UL 982 Section 22.4 及 66.25.1 "with a stop position while energized"
5 C) R! `4 c! O. }( e- u: O
$ G: s/ p4 Q, X% _$ n7 ^5 h- ]" \; F# f
22.4 If a malfunction or breakdown of an electronic component, located in any circuit of the product, results in increased risk of injury to persons, such as a loss of OFF control or unexpected operation, that circuitry shall comply with the requirements in the Standard for Tests for Safety-Related Controls Employing Solid-State Devices, UL 991. A single malfunction is to be considered at a time.
; z( M( }7 r9 Z6 d( ~( \ RException: An appliance employing exposed moving parts and electronic controls with a "STOP" position, where a single malfunction of a component can cause unexpected operation, shall be provided with a motor control OFF switch in accordance with 17.4 and be constructed with a red light which flashes only when the appliance is energized and when the motor is in a stop condition but not OFF. See also 66.25 and 70.32.
# X% G- j$ u C% a66.25.1 Products employing exposed moving parts and electronic controls with a stop position while energized, and required to be provided with a flashing light in accordance with the Exception to 22.4: .... }) Q+ U$ {6 G5 r
1 H7 l* k! b a+ Y2 f. x- T# C9 y- a
9 u* i- B5 w& l
即电源已经启动(energized), 但操作在 stop position, 要求闪烁之红灯(red flashing light)!
+ Z. ]6 B& W1 }/ ~+ Q在 Certification Requirement Decision (2012-01-13) 又作了少许更改, 不一定要 red light:
0 Q o# y: O! I3 [) N% U" y, `9 A6 J6 H# w7 ^3 s: E; j
% p& }6 I0 Y) D& @# ~
.... shall be provided with a motor control OFF switch in accordance with 17.4 and be constructed with a light which flashes only when the appliance is energized and when the motor is in a stop condition but not OFF. & s8 U# }; I3 T2 c2 {. m7 [
; L, c9 `( |5 P0 E/ W) B0 D |