|
1st (twice)7 y4 T9 O$ r+ B% }6 `- ]( @
Detachable parts are removed.
0 A- w! D$ I% u! U7 xThe liquid container of the appliance is completely filled with water containing approximately 1 % NaCl and a further quantity, equal to 15 % of the capacity of the container or 0,25 l, whichever is the greater, is poured in steadily over a period of 1 min.# }, I* S* ~ B! e
In case of doubt, the spillage test is carried out with the appliance deviating from the normal position of use by an angle not exceeding 5°.
9 |8 y+ U+ @ r# O* `
f+ T0 Z: O1 H/ V+ {2 A* [+ ]For cordless kettles, the test with the kettle on the horizontal plane is carried out with the kettle both on and off its stand.$ y8 _8 D9 A a
* z7 @. f8 t4 m6 }! T0 x2 J; C* v) d1 `) @, a, c% [( \* r. V
2nd -- Kettles that can be filled through the spout # K3 O# y8 Q1 |9 N. ]
Detachable parts are removed.3 i5 S% T% ~% Q
Tested on a plane inclined at an angle of 20° to the horizontal, with the spout uppermost.: [7 t% D; R4 \: c% J5 a0 X6 W
filled with water containing approximately 1 % NaCl to the maximum level, if this indication is visible from the filling position, otherwise until water spills from the kettle.
; {& P# D6 Z4 Z* e1 v: W4 yA further quantity, equal to 15 % of the rated capacity of the kettle, is then added as quickly as possible% D! O# h6 G0 y( h
Only with the cordless kettle off its stand
( u% t D0 j( l- ?6 S4 L! i
( v( ~0 r( [ H+ F9 O! C* b0 R Q
3 J1 H Z6 R9 ]* D8 s3rd/ I" c; r' c/ D1 I7 b) h& A9 m
Kettles are then filled to rated capacity with water.
& y* X0 Q3 G2 B: [They are placed on a plane inclined at an angle of 20° to the horizontal with their spout facing up the slope of the inclined plane.
0 ]4 f7 H1 ~9 r$ I' R AWater shall not be discharged from the kettle
+ }4 j4 {" _: S& x6 n$ V3 _8 |! d! M& V2 C; m* n$ C @5 _
) C0 k8 z* R8 }' f6 V: g/ z( X
9 ?6 y+ L5 J% n3 ~4th -- Stands for cordless kettles
% Z+ X+ p0 b& t- E; _8 X1 K4 {The stand is placed on a horizontal surface + e# H# G) k1 B/ M0 |. I
30 ml of water containing approximately 1 % NaCl is poured onto the connecting device.
. c* |0 J, F8 R4 P. ^7 [The solution is poured steadily through a tube having an inner diameter of 8 mm over a period of 2 s, the lower end of the tube being 200 mm above the connecting device.
9 T" G; Q$ ?" uJudgment:The stand shall then withstand the electric strength test of 16.3, the test voltage for reinforced insulation being 2 500 V. |
|