|
Background: OSM 2012 found it useful to have a similar decision for EN 60065 as the decision 01/8 for EN 60950-1. It has lately been questioned by the chairman of IEC TC108/MT1 that the decision 12/2 may amend EN 60065. Thus, we are proposing a revision of 12/2. Ref. OSM/EE – 2007 Item No.7.1 (enclosed):( I6 [7 T; d3 N8 w8 }
“OSM decision 01/8 requires markings on the product (e.g. "Use only power supplies listed in the user manual / user instruction." or “For applicable power supplies see user instruction”). Furthermore such sentences shall be in the languages acceptable to the country where the product will be used.
8 v/ ?. |% Y; D" EWe cannot assume that all people speak or understand English and therefore it is necessary to put nearly all languages of such relevant safety instructions on the product.
; Z* a2 a2 I. ^7 o, s' d. oThat cannot be a solution because many products are too small!”
) g# t' @3 o4 F! mOSM/EE-2007 agreed to use instead of such instructions (sentences) on the product, international accepted symbols like these both marks (ISO 7000-0434 and ISO 7000-1641):
) O8 b) }2 O) C: c: W C6 Y6 KLater it was confirmed by TC108/MT1 that the book only can be used as an alternative. See explanatory notes below. Based on this it is proposed to revise decision 12/2 as amended with red text under the decision below.
* l) r# ^6 n7 U* i4 u0 I; e. oIn case safety of an end apparatus relies upon the power supply for general use (adaptor) to EN 60065 apparatus, the use of the specific adaptor needs to be controlled.
# i9 k: r. z8 w3 N3 fThe safety issues may relate to a reliable insulation, single fault conditions, heating etc.8 e2 V/ n+ J- \# u
Extract of 5.4 Instructions:. |. m$ G0 f# X5 m
When information with regard to safety is required according to this standard, this information
s" ^6 `' U) [shall be given in an instruction for installation or use and supplied with the apparatus. …
$ h% @3 Z5 \* k _It would be useful to have a similar Decision for 60065 as the Dec 01/8 to EN 60950-1.
6 t* D5 ?2 ~# c4 j' k2 ^/ J# k; O: hDec 01/8 is enclosed for convenience.
+ o! I) S# e, `) r3 _( C" \* L Z: J5 ^2 F
Decision: This decision replaces 12/2 with the amended text in red:) h2 m% ?. ^3 n) ~! r& c
When safety of an apparatus relies upon the power supply (adaptor) using a non-special connector for the a.c./d.c. input, the apparatus must have a marking stating the following: "Use only power supplies listed in the user instructions"
9 u6 I6 H# Q6 U. x1 X! p2 Por
. q' T. O% U! S"For applicable power supplies see user instructions". This statement shall also be in the user-instructions.
5 T. W8 |: V1 e& pThe user instructions must then have a listing of manufacturers and models of the relevant power supplies. As an alternative to the text on the product, it is acceptable to use both the symbols ISO 7000-0434 and ISO 7000-1641. The book alone is also sufficient (ISO 7000-1641).% Y8 h- E. J" @& o. P7 o$ B2 g
& r" K/ x5 E8 a/ l |
|