此为一adapter，Rated input： 100-240V 0.35A 50/60Hz Single Phase/ Z$ t- [+ ?- u1 {) {
Rated output： 5V 2A % ~# _+ I% i9 p) a9 C' \- \
Maximum Output Power: 10W
; a' V5 m3 Y( t# o* \: J Maximum Ambient: 40 C(度)
7 n0 d/ n7 s7 ?3 y希望安规前辈能对data sheet中的点进行讲解（标准的理解，本项测试的本质，每项被测数据的测试方法，仪器选用的原则，测试过程中的注意事项），以供大家交流讨论以及新人学习之用，谢谢！. H3 @# d1 R# d$ |& U% [
3 m: M9 U& x" p& \8 m: e& c
1.2.2.1 –MAXIMUM OUTPUT VOLTAGE, CURRENT, AND VOLT-AMPERE MEASUREMENT TEST METHOD A sample of power supply, Model ______was connected to _240_[Vac,_60_Hz][Vdc]. The following parameters for each output were measured: A: The maximum peak output voltage (V) under any resistive loading condition. B: The maximum rms output current (A) under any resistive loading condition [after][at] 60 seconds. C: The maximum volt-Ampere (VA) under any resistive loading condition [after][at] 60 seconds. RESULTS | Output tested | Maximum | HAZ/EL[Yes][No] | (V) | (A) | (VA) | 1. | | | | | | 2. | | | | | | 3. | | | | | | 4. | | | | | | Comments: |
8 q0 Q& V* K$ R+ k8 B* o
NOTES TO LAB: 1. Output which exceeds 240VA is considered to be hazardous energy level (HAZ/EL). 2. Indicate the load used for each test condition. NOTES TO ENGINEER: 1. Indicating loading condition (s) for output (s) not under test. 2. These measurements are to be taken for QQGQ2 Guiducard information. Addition testing in the end-use application may be necessary to determine if an energy hazard exists.
& A4 v6 t' [+ U" I& q, W* e& g1 \; C: ]
| 
/1 
|关于安规|小黑屋|安规QQ群|Archiver|手机版|安规网
( 粤ICP13023453-10 ) 
窥视卡
雷达卡
发表于 2012-2-18 14:48
提升卡
置顶卡
沉默卡
喧嚣卡
变色卡
抢沙发
千斤顶
显身卡
发表于 2012-2-18 14:55
