|
现在我担心的是我们产品本体上有A1234,包装的标签上改为A-1234.细则上也是A-1234,包装与细则一致,但本体上的也细则不一致.这样会不会有问题,还是只要在一个地方的标识与细则一致就可以了?
2 s1 h, y; H, I: `* Q# G/ L/ ]1 X因为细则上是这样写的:
( z' h" u3 K9 G6 g) G0 T; wThe required Markings may be displayed in any of the following locations:
" g: @5 l# q! i% n X1 Z1 }* x+ X' y* q2 f6 y: U
A) On each part.* `" l2 O8 z+ n* n; B: a% {" @$ n
B) On the specification sheet packed with each shipping carton.
5 p( _+ n. L0 _6 f. O C) On each shipping carton.: J, l" T- g* y
D) It is not necessary (but recommended) that all the required Markings appear at the same location./ |. I4 Z8 B4 k; f' Y' i
按这段话理解,是说出现在任何一个位置都可以.那是不是相当于有一个地方一致就可以了?涉及到的模具多,费用也高.不敢轻易做决定.想听听各位大虾的意见. |
|