最近在看IEC 62133：2012 的标准经常遇到问题，请兄弟们帮忙解释，谢谢

yangcanluck

广东安规检测
有限公司提供：

小型摆管淋雨试验机

IPX5X6X7喷水试验机

1000L恒温恒湿箱

各种试验指现货

可程式恒温恒湿试验箱

水平垂直燃烧机

自动卷线器试验机

耐划痕试验机

各种灯头量规现货

灼热丝试验机现货

GB1002插头量规

IPX1-X7淋雨现货

IEC61347/UL935镇流器热试验箱

灯具防风罩

IK冲击试验机

UL498插头插座量规

VDE0620插头插座量规

稳定性试验台

家电温升测试角

针焰试验机现货

热电偶焊机现货

家电125mm试验指

E12灯头量规

无绳壶无绳电熨斗插拔寿命试验机

IEC60335试验指甲

9 _0 }7 x6 R2 `# O% B: L最近在看IEC 62133：2012 的标准经常遇到问题，如8.3.9条款中有一段话，不是很理解还请高手帮忙分析分析。
- F% i7 J4 ?0 G4 F1 I$ QBottom surface of movingpart of the press equipment is made of Nitrile rubber or Acryl, which is put onthe 10 mm x 10 mm stainless steel shaft. The detail of pressing jigs shall beshown in Figure 2. Nitrile rubber bottom surface is for cylindrical cell test.For prismatic test 5 mm x 5 mm (2 mm thickness) Acryl is put on the Nitrilerubber. The fixture is moved down at the speed of 0,1 mm/s monitoring the cellvoltage. When voltage drop caused by the internal short circuit is detected,stop descent immediately and keep pressing jig in the position for 30 s andthen release the pressure. Voltage is monitored m-ore than 100 times per secondand if voltage is dropped more than 50 m V compare to the initial voltage, itis defined to internal short circuit has occurred. If the pressure reaches 800N for cylindrical cell and 400 N for prismatic cell, stop descent immediatelyand then keep in the position.

哥哥们帮帮忙！这该怎么测试呢！

novice-safty

这个测试过程说的比较明显吧，并且要相应的治具，后面有图。
你确定要做这个测试？你确定这个cell不是聚合物的？
8 f: w! Q8 t. {4 k' J看下8.3.9 a）This  country specific  test  which  is only applicable to France, Japan, Korea and
) R2 ]! G- c. x! V: t6 ?Switzerland and is not required on polymer cells.
$ d+ {9 N( b& @- n/ K6 V" P/ B8 Y这个测试需要动手能强，先拆电池，装镍片，然后又装起来。我手脚不灵活，搞不定

happysarah

正要学习电池标准，可否分享一下给我相应的标准呢？多谢多谢！