|
0 N- P4 d: k- f+ A
, x/ T8 {5 }, |3 |# w | Components
/ I) p" K6 ~ ~2 r) M0 V | 14. r4 c' f/ P2 `1 s" y- O6 x
| 61010-1(ed.1);am1;am2
, d/ {( J* q! @+ e | 6 Y+ o6 P( s( \7 G, n
) {$ m6 L1 T3 X' r1 u4 b" h; R
Standard:
+ F( W; m5 }6 M; s, N. JIEC 61010-/ [/ B% Q& v; ]2 S# @$ Q0 S1 L
1:1990+A1:1992+A2:1995
7 `' u3 m M0 Z- o' a1 c- `, i2 p3 bSub clause:" E2 E* R' p2 I1 `! V+ t
14
) ?$ h: g- N$ K% NSheet n. 3101 M3 J) {- ]: z v$ X7 v1 s
Page 1(1)0 q7 n+ c' l+ E# e8 O7 o
Subject:5 q" w: V. L7 g$ R! ~) `
Components
8 z' X# y" Q' A) K4 N4 n$ f$ h0 XKey words:8 L( _7 F# h4 e: `
- Transient5 B+ f# O# B0 t# U: G
- Suppressor
( p: ^2 H+ ~' x/ O: W0 [" w/ v- Mains
3 Z' R2 {1 w# WDecision taken by c! V7 S2 o: @* ^
ETF3 and confirmed
9 y/ ]7 [7 C" i% Pby CTL at its 38th. k% E2 q! H& {7 p) N) _1 b
meeting, in Toronto
2 I1 [ `# N# J% cQuestion:6 [% {% _ Z4 N% n: e
Is the use of transient suppressor devices such as varistors accepted in equipment and, if so,
, D( }) X6 R- xunder what conditions+ i; M8 [/ V2 K' \7 }% e+ ^
Decision:
" j; Z8 |( _- s0 M3 R( RVaristors are accepted in the following conditions:
' k8 T/ ~3 z2 g. B! M, @6 p, ]: j1 Between Live and neutral conductors after the mains fuse.
1 }8 N; T# X; c! \+ O* KNo component approval demanded." @- o& l* @8 V r, v/ e1 X Y
2 Between Live and neutral conductors, before the mains fuse.- K. A" V! F% l0 I
Only accepted if the component is approved to an international standard (IEC 61051 or
9 k, F; s9 {/ @( i4 ECECC 42200)+ n- b" x# l I4 |0 d
3 Between Live and Earth conductors (before or after the mains fuse)
) |/ s' a) Z' R0 q; o }0 w( }a) pluggable equipment1 U/ p: V! }" u5 K P9 w
devices are not accepted1 H/ d5 v. U+ U3 z8 H4 P
b) permanently installed equipment9 |9 f5 U# R" j0 f# F
devices are accepted as in 1 and 2 above.
8 {% A8 ^1 M/ p/ a; H& qNote: Components shall be physically mounted in such a way that no hazard can arise in the$ \; y O4 ~) e( H9 E
event of the device failing catastrophically.
$ C7 R* @% l4 V2 f, sExplanation:
3 G& q, c1 i( J) M. pVaristors are semi-conductor devices and therefore, cannot be treated as high integrity, e' k! J8 ?) }4 ^- G8 `* f) X
devices and must therefore, always have additional protection.3 Q( v: L/ b* y @! F/ X
Varistors in the equipment or installation coupled with safe construction and approvals meet
; ~& D Y/ h/ g2 zthese requirements except where the disconnection of earth is possible as a single fault. In2 L( S) O. e1 @- ~& i% x1 I. z
this case, the slow deterioration of the device with time, allowing an increase in earth
: V' z- `: ^( }4 k7 E% N) _leakage current, is not acceptable and the devices are, therefore, not allowed.
& y% P9 y0 N7 @$ i8 M& g
7 p; f9 q0 C8 S, t5 F8 B; q/ X! ?4 M) {* ~" Z
. I2 L6 _8 U7 T |
本帖子中包含更多资源
您需要 登录 才可以下载或查看,没有帐号?注册安规
x
|