DSH 725A Abnormal operation

小米

广东安规检测
有限公司提供：

小型摆管淋雨试验机

IPX5X6X7喷水试验机

1000L恒温恒湿箱

各种试验指现货

可程式恒温恒湿试验箱

水平垂直燃烧机

自动卷线器试验机

耐划痕试验机

各种灯头量规现货

灼热丝试验机现货

GB1002插头量规

IPX1-X7淋雨现货

IEC61347/UL935镇流器热试验箱

灯具防风罩

IK冲击试验机

UL498插头插座量规

VDE0620插头插座量规

稳定性试验台

家电温升测试角

针焰试验机现货

热电偶焊机现货

家电125mm试验指

E12灯头量规

无绳壶无绳电熨斗插拔寿命试验机

IEC60335试验指甲

DSH 725A 1 [) D4 B* X7 h$ w$ e

Abnormal operation * z: x2 Q# e, N+ E2 L5 u

19.102(IEC 60335-2-6) 19.104(IEC 60335-2-9)

60335-2-6(ed.5) & 60335-2-9(ed.5) % b" W2 I+ R6 m' q# B/ |+ V  X

Question:
In clauses 19.102 of IEC 60335-2-6:2002 and 19.104 of IEC 60335-2-9:2002, it is required to short-circuit the thermal control for the test. Note 5 of Sub-clause 19.1 of IEC 60335-1:2006 explains that instead of short-circuiting, controls may be rendered
inoperative.
( [& Q0 U- s+ W0 l4 v- n2 sIn induction hobs, the thermal control of hob elements is normally a NTC controlled by the micro-controller. Short-circuit or open circuit of the NTC is easily detected by the micro-controller, but fixing the NTC in an intermediate value may not be detected.
6 Y1 B3 N( m7 S2 R+ m5 pIEC 60730-1:2007, Annex J has requirements for thermistors. There is a test for the drift of the R/T characteristic when the control is classified as Type 2.
Should the NTC be fixed at a specific value so as to render the thermal control inoperative? What is the condition required to be checked by clause 19.102?
( A  k- D  B, B$ o" vDecision:
The NTC can be fixed to a specific value. This value must be in the middle of the operating range of the NTC, so as to avoid hysteresis problems that may happen towards the end of the range.