|
如何对电吹风分离电路做39.3.3和39.3.4?UL859% E _) i' ~ N4 U& x
The air inlet opening shall be gradually obstructed until the operation of all circuits is interrupted
) f3 @3 q5 Q" A: S" C& a: I! }by the functioning of a limit or a temperature control, or until ultimate results are otherwise obtained* j1 g* v' X* Q+ |. y. @: f
39.3.4.2 The air outlet is to be gradually obstructed using masking tape such that approximately 50, 75,
& E1 v9 j3 [* m7 C5 y90, and 100 percent of the outlet opening area is progressively blocked for 3 minutes at each of the four) Y6 f5 U( r- M
positions. For each of three samples, the location at which the blocking begins (the top, a side, or bottom)8 P1 @( X; T* A
is to progress in the same direction in which it was started and is to be such that the limit control will( y: c& E9 s% c) { X- V
remain in the air flow for the longest possible time as blocking progresses. If temperatures cause
( J4 o* }* q6 U% o/ Z3 d0 W7 Rdegradation of the tape, or if the use of tape would cause deformation of an outlet nozzle, a metal plate
* u: w, f8 p- t! F: ?: d: f0 jor other material resistant to combustion may be used to block the outlet opening. If the final 100 percent
1 M. H! N9 f5 ^+ V. }blockage test does not result in interruption of all heater and motor circuits by a limit control, the test is to) J0 R7 V6 ?0 z& w9 H
be continued, at 100 percent blockage, for 7-1/2 hours, at which time ultimate results are considered to& Z- X/ Z4 P3 l" D5 H7 T- m1 k
be achieved.
: G) ^" @$ e5 }" \, N! m Z是不是TCO动作了不停止了,还是做到最终结果或者是FUSE开路? |
|