年華 发表于 2016-9-23 08:42 
! R9 \, ~6 J. E! `! ]6 y7 {謝謝回覆，我有查了UL，檔案裏面寫的是需要印廠商名字和材料型號，沒有說一定要把RU印上去呢，
4 t% E6 y: T6 o( G2 I, B0 m- s当真?; A' x( H1 v5 c, P5 @
通常 UL 档案内有一个叫 EXXXXX-VolX-RecCompMarkData.rtf 的文件, 内有这样说明:
% X1 N e& `. E9 l6 V% Q
5 o3 E4 b- Q% VRecognized Component MarkingData Page (RCMDP) (File Immediately After Authorization Page) RECOGNIZEDCOMPONENT MARKING
4 a$ I, s8 C; c1 Y4 {, n+ v, CProducts Recognized underUL’s Component Recognition Service are identified by marking elementsconsisting of:, f: K' a; A* K
7 G3 }/ ?) ?( F- g 1. The Recognized Company’s identificationspecified in this document. % Q i! ^ C" k& \ e
2. A catalog, model or other applicable productdesignation specified in thedescriptive sections of this document. 7 {% K$ _7 t6 ?( r! M
3. The UL RecognizedComponent Mark shown below.
4 H" |/ `: R2 B4 Z& v0 h " V) Y; Z! D5 Y6 l
Onlythose components, which actually bear the Marking, should be considered asbeing covered under the Recognition Program. The UL Listing or Classification Mark is not authorized for use on or inconnection with Recognized Components.
9 c, w4 G' g3 c7 J
/ x( r: I# z6 [) t9 n" kRecognized Component Mark
- g) Q. L% |* H* i7 w
9 N& c0 o4 M6 K1 X. G( K1 ?) s; H M. o# t
Minimumsize of the Recognized Component Mark is not specified as long as it islegible. Minimum height of theregistered symbol ® shall be 3/64 inch but may be omitted if it is out ofproportion to the Recognized Component Mark or not legible to the naked eye.2 t( w& C$ u O# y. i$ `: B
4 a' p; A( ~; O. O. G
& i2 w0 G. C, P# I% H) RThemanufacturer may reproduce the Mark electronically. Any decision regarding the acceptability ofthe manufacturer’s Mark reproduction will be made at the Reviewing Office.
/ o4 j; ]. g7 o. R5 E1 }# f
- Z5 I2 f' G q. p( x4 s% D1 d8 E9 R0 j% Q& W4 n: W. @
| 
/2 
|关于安规|小黑屋|安规QQ群|Archiver|手机版|安规网
( 粤ICP13023453-10 ) 
窥视卡
雷达卡
发表于 2016-9-22 16:28
收藏
分享
好帖
鸡蛋
提升卡
置顶卡
沉默卡
喧嚣卡
变色卡
抢沙发
千斤顶
显身卡
发表于 2016-9-22 18:40
楼主
