|
求组各位EMC大大~~0 k G% m% E2 _! ~) a/ k' o2 t
% Y6 B! [7 x9 Q
+ s. E- a% U% Y2 f+ M' H章节6里面A simplified test method is permitted for equipment that undergoes minor changes or updates,
- v h) ]% {5 t5 s, Fprovided that, in previous full compliance tests, it has been shown to have current emissions5 c+ g! s8 [9 ~& J; u( n; g8 C3 P2 n
below 60 % of the applicable limits and the THD of the supply current is less than 15 %. The
+ J6 \7 h3 ~* _' f7 `6 Qsimplified test method consists of verifying that the updated equipment has an active input
) g# x! t! {4 H6 G: B G8 X/ Epower within ±20 % of that of the originally tested product, and that the THD of the supply
& K( T1 c H) u* ncurrent is less than 15 %. Products that fulfill these requirements are deemed to comply with
2 ^5 U3 I; D T% [the applicable limits, but in case of doubt the result of a full compliance test according to( P: {; q3 f$ K, r0 Y* t
Clauses 6 and 7 takes precedence over this simplified method.这里是指测试产品之前经过完整的测试,假如对产品进行了细微的升级。. B9 J; T9 Q: R) H
我之前完成测试时满足谐波低于60%,THD低于15%。
4 E+ V/ K3 s) u& a那么我升级之后的产品如果功率在原来的±20%之间,THD测试值仍低于15%。我就认为是符合要求的?2 F8 X$ z' y" [. ?" J. u! s' C
" q: f& y( c8 r) b! K% S" E
( R6 \0 X" B1 {$ H |
|