|
--On August 24, 2017, ASTM International published ASTM F963-17, Standard Consumer Safety Specification for Toy Safety. The new standard is a revision to the ASTM F963-16 version. ASTM F963-16 became mandatory by CPSC rule on April 30, 2017. Under the CPSIA, it becomes mandatory within 180 days of publication, unless rejected by the US CPSC within 90 days., {* K5 ^5 F% n' | C. q
---Pull and push toys:. o# E* `0 X* o
4.5 Exemption: (7) sounds quantified by A-weighted equivalent sound pressure level, LAeq, produced by pull and push toys as a result of pulling or pushing.4 L$ A+ l J. m+ Q- W
4.5.1.2 The maximum A-weighted sound pressure level, LAFmax, produced by the translational motion of floor or table top toys where the motion is imparted on the toy by the child (see 8.20.1.5 for a greater description) shall not exceed 85 dB.( a L6 C# a) I: e
8.20.1.5 (5) Floor and tabletop toys that move, where the sound is caused as a result of the movement imparted on the toy (for example, a noise making mechanism attached to an axle of a toy vehicle) shall be tested using the method for push and pull toys. In addition to the C-weighted peak measurement a maximum A-weighted sound pressure level, LAFmax, shall be made and compared to the requirements of 4.5.1.3 4.5.1.2. The toys described in this section do not include push/pull toys as defined in 3.1.68. The scope of requirements for push/pull toys are given in 4.5 (7).! P7 {* f: X& r$ B) K8 J9 {
---Projectile toys:3 L1 S" K, H/ C5 b
Projectile Toys with Stored Energy& C5 Z" K7 W% h3 Q/ _/ Q2 A4 M4 p
4.21.2.3 Projectiles that have a kinetic energy greater than 0.08 J when tested in accordance with 8.14.5 shall not have a kinetic energy per unit area of contact, also known as Kinetic Energy Density (KED) greater than 2500 J/m2 when tested according to in accordance with 8.14.6.5 ~# ?, ^ _# q8 e" T
Projectile Toys without Stored Energy3 P" f& X( |, u1 @8 i- u
4.21.3.3 Arrows intended to be launched from a bow (that is, bow and arrow set) that have a kinetic energy greater than 0.08 J when tested in accordance with 8.14.5 shall not have a maximum kinetic energy per unit area of contact (KED) that does not exceed contact, also known as Kinetic Energy Density (KED) greater than 2500 J/m2 when measured tested in accordance with 8.14.6.# F8 R- Q1 ^# g3 k# V
|
本帖子中包含更多资源
您需要 登录 才可以下载或查看,没有帐号?注册安规
x
|