|
Background: OSM 2012 found it useful to have a similar decision for EN 60065 as the decision 01/8 for EN 60950-1. It has lately been questioned by the chairman of IEC TC108/MT1 that the decision 12/2 may amend EN 60065. Thus, we are proposing a revision of 12/2. Ref. OSM/EE – 2007 Item No.7.1 (enclosed):8 ?3 _. k; m$ \, q2 o+ d$ u( p
“OSM decision 01/8 requires markings on the product (e.g. "Use only power supplies listed in the user manual / user instruction." or “For applicable power supplies see user instruction”). Furthermore such sentences shall be in the languages acceptable to the country where the product will be used.- ?( C6 s0 r3 C% K) b/ o
We cannot assume that all people speak or understand English and therefore it is necessary to put nearly all languages of such relevant safety instructions on the product.
, X6 n3 ]6 \# r' i- LThat cannot be a solution because many products are too small!”
1 W) t4 `/ l4 eOSM/EE-2007 agreed to use instead of such instructions (sentences) on the product, international accepted symbols like these both marks (ISO 7000-0434 and ISO 7000-1641):
7 r8 `4 z3 n2 {3 XLater it was confirmed by TC108/MT1 that the book only can be used as an alternative. See explanatory notes below. Based on this it is proposed to revise decision 12/2 as amended with red text under the decision below.1 b4 |+ b3 P2 A
In case safety of an end apparatus relies upon the power supply for general use (adaptor) to EN 60065 apparatus, the use of the specific adaptor needs to be controlled.
/ r3 d# @$ A: ~0 y6 K: ^3 d4 ?! dThe safety issues may relate to a reliable insulation, single fault conditions, heating etc.9 p5 o" h6 p* y( c# O$ Z
Extract of 5.4 Instructions:8 V8 w( {" v9 L8 ?8 a* ~) D
When information with regard to safety is required according to this standard, this information
4 b! W9 a: m6 N/ sshall be given in an instruction for installation or use and supplied with the apparatus. …* _. E4 n, m* r' W+ j1 R
It would be useful to have a similar Decision for 60065 as the Dec 01/8 to EN 60950-1.
# d; K& [$ H7 S. h* N! J, |Dec 01/8 is enclosed for convenience.2 A" u& R- H" x+ c) w j
! U+ Q" W8 v. `Decision: This decision replaces 12/2 with the amended text in red:0 n2 b: @2 K y- @
When safety of an apparatus relies upon the power supply (adaptor) using a non-special connector for the a.c./d.c. input, the apparatus must have a marking stating the following: "Use only power supplies listed in the user instructions"7 i/ Z6 \/ E0 E, z& f6 d
or
: f; {0 N( Y/ U' k Z"For applicable power supplies see user instructions". This statement shall also be in the user-instructions.
, d7 k$ i4 Z) ? zThe user instructions must then have a listing of manufacturers and models of the relevant power supplies. As an alternative to the text on the product, it is acceptable to use both the symbols ISO 7000-0434 and ISO 7000-1641. The book alone is also sufficient (ISO 7000-1641).
! w/ o* m' c3 j" V
; i- ?( P1 [4 O$ u( i! ] |
|