|
- r! K& I x; X
( l( B4 [$ A8 K! _9 a H8 j& U8 ?DSH 310% f4 {" F p% d) t1 u9 o& K7 B
| Components0 b0 q% S3 Z) G& U: K3 j( K+ ~
| 14
5 }- q3 j& l; R' u+ B J$ r | 61010-1(ed.1);am1;am23 m! f# H8 e: h6 l6 h
|
$ }2 M& R# T1 L/ K4 }+ g; [- _% }7 s+ w$ R$ X8 H
Standard:
. L/ x$ I2 [: {/ DIEC 61010-
: ]1 H7 h2 m2 R5 x% ^. u" r1:1990+A1:1992+A2:1995
# z- w" `1 T; ~+ ^Sub clause:# a9 i2 M& B: v2 _# k4 g4 n+ ~3 P, i
14
- E( V- T2 `' e* k! a7 y; `6 QSheet n. 310
& U. S! Z, m2 gPage 1(1)
* ], I! Z; g: w( p1 G/ t( NSubject:
$ X) B) r, v- B ^Components
+ A) ?5 N7 V! c1 ?2 {Key words:
1 r6 m$ K! O4 W6 q- Transient
9 y! I% h3 U8 v1 _/ p. x- Suppressor% D; O( x7 O4 k; ]" Z6 X
- Mains. ?) \. d' k1 M% @
Decision taken by& w# H: L( ?/ J+ q
ETF3 and confirmed+ t: J* E$ d0 l2 s& {* R' g1 F2 M
by CTL at its 38th; S/ n6 _. B: Q: ? O3 p' f
meeting, in Toronto0 A/ a7 m$ C' d# [6 O! k+ S
Question:
5 b9 t# e* ]- Q8 aIs the use of transient suppressor devices such as varistors accepted in equipment and, if so,
/ N8 [# q9 y4 ~" A7 ~' }' z" E4 _2 junder what conditions
' f, A. B0 [0 mDecision:+ W; t; ]0 j$ b, H# f, B3 h5 M
Varistors are accepted in the following conditions:, r+ ?5 p7 c' [1 K' \6 b! t2 Z
1 Between Live and neutral conductors after the mains fuse.
/ B3 M6 u5 W9 P0 ANo component approval demanded.
; Q7 s' Z& _ I) f8 S) i" E2 Between Live and neutral conductors, before the mains fuse.
[1 Q3 `, i2 c6 b! wOnly accepted if the component is approved to an international standard (IEC 61051 or
7 g6 I$ X6 d2 t2 Z* U" oCECC 42200)" N4 O, ?1 h- V' F7 x
3 Between Live and Earth conductors (before or after the mains fuse)
4 m2 I- K8 n! X: k8 ]( Ya) pluggable equipment k* @0 u1 k7 A. `. ^+ n: ?* x: p
devices are not accepted
( { Y. k! t6 Z' }" Lb) permanently installed equipment) s9 J0 l0 G6 Z8 ?& i( w
devices are accepted as in 1 and 2 above.
; u/ k; m! u( O$ O8 d- ^Note: Components shall be physically mounted in such a way that no hazard can arise in the8 v2 }3 z9 P& o5 {; x* N
event of the device failing catastrophically.3 ~8 M5 D0 w7 O: ?% ?
Explanation:
5 }1 v) p, m! B, J+ v. j$ kVaristors are semi-conductor devices and therefore, cannot be treated as high integrity
* l1 S( Z" x+ \. Z. v9 L) Sdevices and must therefore, always have additional protection., b: @, w4 ]" W$ v, Z+ C
Varistors in the equipment or installation coupled with safe construction and approvals meet
2 J. b( ]$ p& X! ythese requirements except where the disconnection of earth is possible as a single fault. In4 P8 f b, j, F
this case, the slow deterioration of the device with time, allowing an increase in earth* D# ?9 n( z# e6 I6 z% O
leakage current, is not acceptable and the devices are, therefore, not allowed.
# y, X; T' S! E" }' Y* u! v. }: _6 a; c; q% c
" A7 F3 ~$ p' W+ E6 z
* O+ r4 L' ~- @* Q |
本帖子中包含更多资源
您需要 登录 才可以下载或查看,没有帐号?注册安规
x
|