标题: BS1363问题 [打印本页] 作者: kingport 时间: 2011-11-16 23:03 标题: BS1363问题 现我遇到下列问题，望知道的大哥帮忙解决一下。 ) Z7 d+ u/ X( T/ O$ d2 a, p关于BS1363/ 0，75 1，0 /配3A 5A 10A 13A 是参照BS1363哪一点。; D7 p6 h. Y4 l) A' `! M# \
怎么配的。作者: shenhao168 时间: 2011-11-17 08:25
看一下BS1363 -2 table2,不知是不是要这个。作者: hugohugohugo 时间: 2011-12-16 12:54
要看ADG07 OR 14作者: aji 时间: 2011-12-19 11:02
LZ指的是配的fuse，那就看table 2作者: glen 时间: 2011-12-19 11:53
We can try to explain what is permitted by BS 1363-1, even if we cannot always give the reasons for the requirements." C, G/ L7 n. C7 Q9 s; {
Table 2 describes the maximum plug ratings according to the size of cord fitted. * n0 h& t1 z( j; I* w- \The usual maximum rating when fitted with 0.75mm cord is 6 Amperes. % g8 t5 N7 Y7 `/ F$ l- PA rating of 10 Amperes can be assigned, provided that the cord length is no more than 2 metres and the parameters for testing at 10 Amperes are used. These are more onerous than for 6A.4 R+ a- G4 s* M8 e5 C: v. y# G
The test parameters used during testing of your samples were appropriate to the usual rating of 6A.$ k+ l5 g) U G4 C
, I/ f- q2 F0 x% v
The purpose of the fuse in the plug is to protect the cord, not the appliance which the cord is connected to. 8 ~' j" l* ~& t2 N& {- kTable 2 gives the maximum rating of fuse according to the plug rating.+ h/ M& T4 j" L& u( m K8 ]; D
It allows fuses up to 13A to be used with plugs rated 6A, 10A or 13A. & a4 [0 i6 z2 `4 AThe plug must be marked with the rating of the fuse link fitted. , D2 x1 s( b* FThis means that your plugs with 0.75mm cord are rated 6A but could have a 13A fuse and be marked 13A, but they must not be supplied for use where the rms current exceeds 6A. ) t. J$ c4 @* K* i" ~: v3 T(An initial higher current such as for motor starting is permitted). 3 } l" M7 L; M9 }The plugs could have lower rated fuses but the marking must always show the rating of fuse fitted.3 e8 C& `+ V3 Z, p1 r' h0 J
Appliance manufacturers may have a preference for the size of fuse.作者: kingport 时间: 2011-12-25 22:07
谢谢，只可惜是英文的，看不懂。要是中文的就好了。