标题: UL产品的电线警告标签（求助） [打印本页] 作者: YGH011027 时间: 2010-1-18 14:17 标题: UL产品的电线警告标签（求助） 我公司有款取暖器 送UL做认证时 要求在电源线上加警告语标签 哪位DX帮帮忙 应该做成什么规格 内容有什么要求吗？在线等作者: a049405 时间: 2010-1-18 14:38
UL817 PROCEDURE SECTION GENERAL 要求： & J. ?7 l* U' ~( @" W4 Y2 N3 F 美規US Type 電源線AC Cord, 根據UL817規定從去年2006.06.24 就開始要求, 如下文及附件: 6 r8 Q4 W$ Q8 U o0 ]( G$ v/ C) s1 L! U1 a) {7 I$ B
"Detachable Power Supply Cords intended for shipment to Original Equipment Manufacturers, shall have any applicable makings provided on the outer surface of the shipping carton, or on a tag or the equivalent inside the carton. For Detachable Power Supply Cords intended for shipment to original equipment manufacturer, the electrical rating shall be on a tag, or an equivalent, on each individual Detachable Power Supply Cord unless the ampere rating of the flexible cord is equal to or greater than the ampere rating of the attachment plug."" p" ?! ]) ~% o3 e, u3 D ]
作法:) O2 f7 q& [# {9 z' [
將有電氣額定規格electrical rating標籤 貼在電源線上 # }, V V9 H% e8 \2 O* i9 Z. s7 E! s標籤內容字體除高度規定至少1.6mm及字體清晰可見, 標示電流須取最小電流 A 值標示, 範例如下:4 h8 T9 T2 H: {0 P: l! C& b7 T
先核對''UL報告'' 中插頭Plug及尾插Connector及電線cord的通過測試的電流值0 X6 `0 O; ^) e7 t1 n0 {
Example: NEMA 1-15Plug（15A） + IEC C7 Connector（10A） + No. 18 AWG Flexible Cord（10A） ! ^6 H1 j- l& Y) J; o6 z/ @ ( C0 U Y/ g ?: T5 u! @; a; D因為這要求是UL對電源線廠的要求, 電源線廠有義務責任提出符合UL要求的電源線,作者: cjh80156179 时间: 2010-1-18 15:05
多谢楼上的。作者: wbfsy 时间: 2010-1-19 12:58
取暖器是 按照 UL 1278做的吧，如果是最新版本的1278，则需要下面的警告语句，以tag 的形式：2 {9 p3 r( I, c: C7 K
/ _- V1 d; w' n) {
8 C: k% L' e' w3 C& p“WARNING – TO REDUCE THE RISK OF FIRE:: n# j2 o6 n- r" W
1) Do not place any objects such as furniture, papers, clothes, and curtains closer than + R# P4 k4 y5 s* ]& z& J3 ~& v3 feet (0.9 m) to the front of the heater and keep them away from the sides and rear + r: m3 _, C' H+ s- A9 bwhen the heater is plugged in. ' _( g+ J" L: ]/ v2) Do not place the heater near a bed because objects such as pillows or blankets can9 Q! z' y5 {6 ^
fall off the bed and be ignited by the heater. " Q ]5 g0 ]6 N" d3) Always unplug heater when not in use. (This item may be omitted if the heater is 8 @* ?8 X% N$ V/ Dprovided with a clock-operated switch). $ _! v! F2 S1 e5 F# H" a4) Always plug heaters directly into a wall outlet/receptacle. Never use with an 7 e1 g. F* d' E: r0 G# j6 e1 Uextension cord or relocatable power tap (outlet/power strip).8 t. t- T2 l( y% [( G/ T: E8 u2 \
5) Do not operate heater with a damaged cord or plug or after the heater malfunctions,0 n, U. H" n* ]$ Y+ e7 x: m
has been dropped or damaged in any manner. Discard heater or return to an + a0 A6 K2 N; kauthorized service facility for examination and/or repair. * ?5 G$ Y. I/ U6) Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or( [5 G1 Y- `) o6 N: t: _9 b
similar coverings. Do not route cord under furniture or appliances. Arrange cord away8 a$ A4 s; }4 T9 c, i0 E, c9 x
from traffic area and where it will not be tripped over. 6 \ j Y6 k- Y8 s- K* Y( @7) Check your heater cord and plug connections.8 a# \# Y' Y! ^) w) w: U
a) Faulty wall outlet connections or loose plugs can cause the outlet or plug to ) X$ o, X8 j" t" q; \' B C! @3 Eoverheat. Be sure the plug fits tight in the outlet.6 j& \; s5 j r$ s- i; ?; S2 |
b) Heaters draw more current than small appliances, overheating of the outlet % l: b7 u& Y" c a @7 Cmay occur even if it has not occurred with the use of other appliances. % Z( x; X' l' O6 Pc) During use check frequently to determine if your plug outlet or faceplate is ; }, H" o; |+ WHOT!# r. S, R1 `; ]" ]% u: Q
d) If so, discontinue use of the heater and have a qualified electrician check + Y' [1 o: o# h' Cand/or replace the faulty outlet(s).8 w& H7 E4 @) `- q4 y9 K' ~; W
DO NOT REMOVE THIS TAG!”5 a3 [& ^: `5 m' j
2 S9 C2 b1 D5 K. ?5 f) p " a* D8 j/ ]7 O, W! A$ j1 V0 A+ ]9 _& r* z0 P
2楼的回答，为线方面的，整体并不需要考虑+ d I/ F. M! N+ G7 S6 B7 A4 g
尺寸要求如下： j9 H7 l! }* h0 h% ~5 _ . {/ U" \! ^" F$ p2 [; ?- \ 8 H) @7 O1 r9 zThe statements ²WARNING – TO REDUCE THE RISK OF FIRE² and7 k/ f: J+ g* l
²DO NOT REMOVE THIS TAG!² shall be in letters at least 3/16 inch (4.8 mm) in height. The# ?! a! _# v; u! W1 i+ m9 C2 W
remaining text shall be in letters of at least 1/16 inch (1.6 mm) in height.0 |! K( k7 i. l0 x. I
