引用第2楼月亮代表吾心于2007-07-22 11:51发表的 :
蒸汽烫斗。
25.14 Modification:8 S. O5 O& O4 T, B
Instead of the load specified for the cord, the cord is loaded with a mass of 2 kg.5 j6 V. s+ d h& g' ~/ d
Instead the number of flexings specified, the number of flexings is 20000.& l- g6 [0 ? x4 G
NOTE 101 The test is not carried out on cordless irons unless the iron can also be directly connected to the Supply mains during ironing.
Addition:
For steam irons with a separate water reservoir or boiler, the test is made on the steam hose& V+ F. R$ I0 F* `! D0 A( d
and the interconnection cord together. If they are contained in one sheath or otherwise& T! ? ~$ P. v+ t/ [1 b: p1 Q
attached to each other, the assembly is not turned through an angle of 90°. G2 h+ l) J, K2 |
The test shall not result in
- loosening of the hose;
- damage to the hose to such an extent that compliance with this standard is impaired;4 ?# @- a9 M7 A
- leakage from the hose.% R: h. {; |, A [7 Y
3 I' F0 t" ?3 t, V% H4 K- p$ o% k+ M+ N
Appliances are also subjected to the following test while mounted on an apparatus similar to
That of Figure 8. this testis carried out on a separate appliance.
8 \; B: [6 \; `: z2 D' z
The supply cord is suspended vertically from the appliance and loaded so that s force of/ B& Y9 U4 o: E. r: D8 D9 O
10N is applied. The oscillating member is moved through an angle of 180° and back to the
initial position. The number of flexings is 2000, the rate of flexing being six per minute
- K4 ?: y, T# p1 c' W: j+ P
NOTE 102 The appliance is mounted so that the direction of flexing corresponds to that most likely to occur when
The supply cord is wound around it for storage.% B9 E! u. `% X5 H; o, D( x1 c
6 ]) I. s2 Y5 {( _
NOTE 103 The test is not carried out if it unlikely that the cord will be wrapped around the appliance, for Example cordless irons and irons with a separate water reservoir.
欢迎光临 安规网 (http://bbs1.angui.org/) | Powered by Discuz! X3.2 |