$ j6 J& |% T1 D c# v* R: d2 C* MStandard: 9 g6 v2 ^! h# @3 N( VIEC 60950, 3rd ed. ~4 d# k6 V- s5 X
Sub clause:% g$ M3 Y$ b9 B; E5 b
7 ! b. @, d6 N1 u8 r' z A7 DSheet No.1 \0 `( @# _# `6 Q; i6 U
446 ! F7 V1 @) y! ^Subject: , H$ w k' Q! mProtection of users ) y r* y8 ~% H( p; QKey words:) u5 J/ K7 y$ Z
Antenna, voltage surge test" J) b/ ^' E' f; }% K! I. E" w1 V
Decision taken at the 3 m4 T8 ~7 x& {40th meeting 2003 1 H& h$ X4 S6 D( D$ @! Z$ \Question:+ t R7 `" J. ^! e# }: o' M/ ~" Z% B
For protection of users and service persons from transients and voltage surges, what are the appropriate1 r6 [4 x' D. D# S8 b- p6 t
requirements between the following points for ITE connected to an external antenna: : q8 k. f1 q0 |6 k6 n4 |2 u(a) antenna connection and Primary circuits? 6 Q+ w2 N, w( |- n" w2 B/ `5 q6 f(b) antenna connection and SELV circuits when the antenna cabling is coax? , R0 K- F2 e% L* ?; b. V3 C(c) Antenna connection and SELV circuits when the antenna cabling is unshielded twisted pair 8 x# }% c% `+ \( C(UTP)?) i5 X; j, u6 E8 C5 s
See attached diagram.# }4 ]) g$ W- x: c4 ?
Decision: & t/ W5 x/ m& A# G* TSince Clause 7 is in IEC 60950-1, but is not in IEC 60950 3rd Ed, the requirements cannot be used for the 3rd 0 l2 _3 d! C+ Jedition.3 J+ g4 U o& B& B0 t/ [+ V p
This decision applies to IEC 60950-1 3rd edition. ' W/ s, x' u" t, L1 r0 FIn the case of IEC 60950 3rd edition sub clause 10.1 of IEC 60065 6th edition is to be applied, by referring to 9 P; D% `5 R K5 ]6 xIEC Guide 112 2nd edition "Guide on the safety of multimedia equipment".( i, f0 w2 V9 y0 m# V& ?$ g
Although, the test of 10.1 to IEC 60065 requires test between the terminal for the connection to antenna and& g/ C5 m; ~4 X
Mains supply Terminals, and not between the terminal for the connection to antenna and SELV. ' z( E% ?+ l2 T: t" A! G( O0 G1 X9 E( T* T4 l9 T/ Z: e
[attach]77162[/attach]% e, M$ `; u0 j2 ]* j. T. ?
DSH 446