% o" x! x0 d0 A% e; Y" w, L- Y1 i, w , W$ A& g! h! D7 J t# l* r
Mechanical strength* t# x* x( L* t. ~! M; b0 A
21.1010 D2 _8 |9 Z9 C+ t8 D2 J
60335-2-80(ed.2) ! I7 e) r Z% M, j( A% C) L$ N7 t+ y
5 D) K( Q4 @" E# y% N& x7 U
Question:# T$ y5 t% M- S* S M6 B$ _
How should the test of sub-clause 21.101 of IEC/EN 60335-2-80 be performed? . |; R9 c' d" V2 p* F1 _Decision: 1 W4 M' m: n& Y/ n+ \) wThe standard does not require use of the test finger for the pull and push test. It is agreed that the intention of this test is to check the mechanical resistance of the grid wires and not to check the introduction of the finger through the grid gap, that is covered by the test of 20.2 of IEC 60335-1. 3 r9 k; M; E4 l# _1 E+ E6 AExplanatory notes:8 [9 R7 \7 Z' N5 D
The same decision (n.386) is present in the OSM/HA decision list" |. @1 z4 V2 }+ Y3 g
See also the decision taken by TC 61 in Penang on document 61/3368/DC' X' X% J; F! P2 k
+ M3 {! `2 w! Y P
[attach]75723[/attach]1 j# u; A8 A: A9 ~2 d' \" u
DSH 6411 B; e M* J t1 z/ K