xmzzdong12 发表于 2010-10-26 11:54

EMC测试

请教论坛里的安规高手们,不知在小家电类的产品EMC测试RE(Radiated Emission)与CE(Conducted Emission))是否要同时满足?我看标准是可选择其一通过即可。

kamleung 发表于 2010-10-26 13:17

Normally, the household appliance is tested with EN55014-1+EN55014-2. All emision tests are defined in EN55014-1. However,the RE (Radiated Emission) is only applicable to the Toys. Forthe household appliance, the RE test is not necessary.

郭煜东 发表于 2010-11-2 10:45

楼上是正解

nicho87 发表于 2010-11-4 18:23

Appliances are deemed to comply in the frequency range from 300 MHz to 1 000 MHz if
both of the following conditions ( 1) and 2)) are fulfilled:
1) all emission readings from the equipment under test shall be lower than the applicable
limits (Table 2a) reduced by the margin (Table 2b);
2) the maximum clock frequency shall be less than 30 MHz.
If either of condition 1) or 2) is not fulfilled, radiated measurements in the frequency range
from 300 MHz to 1 000 MHz shall be conducted and the limits of Table 3 for that range
applied. In any case the limits of Table 2a in the frequency range 30 MHz to 300 MHz
shall be met.
Table 2b – Margin when performing disturbance power measurementin the frequency range 30 MHz to 300 MHz
Frequency range   Quasi-peak    dB (pW)
200 to 300 0 to            10 dB -
当功率骚扰(DP)200到300MHzQP余量小于10dB时,辐射(RE)是需要测试的。参见CISPR14-1   2009

xmzzdong12 发表于 2010-11-29 16:06

谢谢楼上的大虾们

stey 发表于 2010-11-29 16:40

如果是DC供电,做RE就可了

测试小刀 发表于 2010-11-30 15:34

好贴必顶啊!!!谢谢楼主!!!

okrich 发表于 2010-12-3 21:49

哇塞,都是英文高手啊
页: [1]
查看完整版本: EMC测试