最近在看IEC 62133：2012 的标准经常遇到问题，请兄弟们帮忙解释，谢谢
本帖最后由 yangcanluck 于 2013-8-7 21:01 编辑最近在看IEC 62133：2012 的标准经常遇到问题，如8.3.9条款中有一段话，不是很理解还请高手帮忙分析分析。:'(
Bottom surface of movingpart of the press equipment is made of Nitrile rubber or Acryl, which is put onthe 10 mm x 10 mm stainless steel shaft. The detail of pressing jigs shall beshown in Figure 2. Nitrile rubber bottom surface is for cylindrical cell test.For prismatic test 5 mm x 5 mm (2 mm thickness) Acryl is put on the Nitrilerubber. The fixture is moved down at the speed of 0,1 mm/s monitoring the cellvoltage. When voltage drop caused by the internal short circuit is detected,stop descent immediately and keep pressing jig in the position for 30 s andthen release the pressure. Voltage is monitored m-ore than 100 times per secondand if voltage is dropped more than 50 m V compare to the initial voltage, itis defined to internal short circuit has occurred. If the pressure reaches 800N for cylindrical cell and 400 N for prismatic cell, stop descent immediatelyand then keep in the position.
哥哥们帮帮忙！这该怎么测试呢！
这个测试过程说的比较明显吧，并且要相应的治具，后面有图。
你确定要做这个测试？你确定这个cell不是聚合物的？
看下8.3.9 a）Thiscountry specifictestwhichis only applicable to France, Japan, Korea and
Switzerland and is not required on polymer cells.
这个测试需要动手能强，先拆电池，装镍片，然后又装起来。我手脚不灵活，搞不定:lol 正要学习电池标准，可否分享一下给我相应的标准呢？多谢多谢！
页:
[1]
